Boba Cat Cell Phone Stand Keychain

Share this:

This kawaii boba-cat keychain serves as a cellphone stand that you can conveniently bring with you everywhere.

Glue for assembly: required. This model has many very small pieces (especially the eyes and whiskers) that may require tweezers to put on. It’s done this way because I want to keep the keychain relatively compact.

Support / AMS / Raft: not needed

Approx dimension: 1.5″ diameter x 1.75″ height.

Slot width for cellphone: 13 mm.

Slot height: 30 mm.

Keychain metal ring dimension: 9mm diameter, 2mm ring hole.

This item is not intended to hold a tablet, because a table would put too much load on it and it would likely topple.


The license is CULTS CU-ND (Cults COMMERCIAL USE – NO DERIVATIVE), as defined by Cults3D.

You can:

  • copy and distribute 3D prints of the 3D model for any use, including commercial, in unlimited quantities.

You cannot:

  • Share your 3D prints without attribution
  • Adapt or modify the 3D model
  • Distribute or resale the 3D model file(s).

Go here if free non-commercial models are ones you’re looking for. Otherwise this is where all the ones for commercial use are.