Simple Bud Vase

Share this:

This simple bud vase listing includes 2 models, one with 2 holes that you can put string through to hang, and one without. I use this as a propagation jar.

3 walls with 0.4 nozzle, 0.2mm layer height. This has been enough with PLA+ to make it water tight.

No infill necessary.

Supports are optional (print slow) but to get smoother external wall on the overhang bottom, you can use supports. No supports needed in the internal.

This model is quickly printed and uses little filament.


The license is Creative Commons BY-NC-SA – ATTRIBUTION – NON COMMERCIAL – SHARE ALIKE, as defined by Attribution 4.0 International (CC BY-NC-SA 4.0).

You can:

  • Share: copy, distribute and communicate the material by any means and in any format
  • Adapt: remix, transform and create from the material for any use.

You cannot:

  • Share or adapt without attribution
  • Share or adapt under different conditions
  • Use commercially

Go here if models with commercial license are ones you’re looking for. Otherwise this is where all the free non-commercial ones are.